I liked the idea of using D-Sub Contacts for connecting the wires to the trim tab servo so I could heat shrink all the wires. Connected the 5 each D-Sub contact pins and sockets together and used 3/32" heat shrink to hold them together. After the heat shrink was done over the connectors, then slid a piece of 1/4" clear heat shrink over all of them to hold everything together. Cleco the servo and push rod assembly into place. Checked the full up and full down deflection to make sure I still have the desired degrees. I'm getting about 28.5 degrees each way. Made the hole in the elevator skin, that the push rod comes through bigger, but still need to trim some more.