Installed A4 rivets along the lower trailing edge section on the R/H inboard slat. Clamped a 2x4 5.25” from the edge of the work table. Used four straps and strapped the R/H inboard slat down over the 2x4. Kept tightening the straps until the holes lined up on the upper side of the slat. Cleco then rivet with A4 rivets. Sanded the rough edges on the fiberglass slat tip. Trimmed the trailing edge back on an angle. Marked 10mm line from the edge of it. Slid the tip into the slat until I could see my line. Drilled the holes to an 1/8”. Debured holes and installed with A4 rivets.