I fabricated a bracket out of 6061-T6 .040 aluminum to hold the fuel lines and wiring along the R/H wing trailing edge. I made it at the same angles as the inboard trailing edge skin but when I put the bracket on the other edge the angle was off. Removed the cleco's on the outboard trailing edge and adjusted it to the same angle as the inboard skin. I reached out to Zenith if the trailing edge pieces should be consistent all the way down, they said yes as I figured. The bottom boles still lined up but the top holes are now off by half a hole. Looks like I'll need a new outboard trailing edge piece. I've triple checked the entire wing and everything else looks great. All holes have lined up great so not sure why this piece is a little off. I could probably leave as is but it will bother me not being right on.