Working inside the wing sucked. But with a little effort, I was able to squeeze my left arm in to hold the bucking bar and my friend Vlad bucked with the gun; it would be a difficult task solo. Most of the gap fairing is done. The easier way to roll the blue off is to put a couple pieces of tape for the first couple inches of blue, and then just roll it off. Quite a bit easier than the pull method. I just used a razor to cut the blue off of the pipe. I ran wire for the wingtips, two 3C20GA and then one 3C22GA, plus red and black 14GA for the pitot heat plus a white 22GA for the heater control discrete switch. For the fuel sender, I realized there is no clear path aft to the wing CPC plug, so I'll have to make a separate hole and run that 20GA wire by itself to the panel starting in front of the spar; I'll use a 3/16 snap bushing and knife connectors in the wing attach area with clear heat shrink.