I followed the Section 24 instructions to install my Aveo ZipTip using the the KAI as described with #6 nutplates. It worked out fine, but one issue is that when fully pressed into the wing end, the tip trailing edge is slightly below the aileron, which is rigged to the flap at reflex (firmly against the spar), so the trailing edge of the wingtip needs to be redone to line up. I will split the trailing edge and then slightly flex the wingtip into rig, and epoxy it into place. I bought another can of West System 206B slow hardener and 105B resin, along with new 300 series pumps. I now have more than sufficient epoxy to finish the airplane.