Took about a week for these to arrive from Australia. Took about an hour to put them together. The hardest part was installing the tiny little e1 leg nut plates in the taxi light plates. Rummaged through my toolbox and found a small diameter. squeezer set that worked. Mocked them up in the leading edge left wing. The previous owner had started installing a couple of halogen lights in there and had drilled holes in the ribs to accommodate a non-duckworks (home-made) mount, so I knew I might run into trouble if I tried to use a Duckworks mount. Spent about 12 hours so far building my own mounts that will work with holes that are already there, as well as the non-standard leading edge holes that were already cut. More on that in the next entry.