Accomplished a number of items over the past few weeks: - Cover glair shield w/ vinyl. Tried the Gorilla spray first but was not happy with the outcome. Bought 3M 77 spray adhesive - Fitted rudder fairing..a couple of times! When I glassed it together I must have pulled it apart a little too much and when the part cured, it was too wide. I cut it apart and did it again. Made a better jig this time and it came out better. - Worked on fitting the Tundra Trike wheel set-up. I discovered that the wheel I ordered from Grove was a different part than what Glasair designed the Tundra Fork. I worked with Grove and ordered the correct bearing seal rings that will hopefully allow my wheel to work. - Received a replacement Garmin GPS antenna under warranty and replaced it. Worked fine and everything is working correctly now. - Found grey vinyl locally and completed the covering of the bulk head cover. The 3M 77 spray adhesive worked well. - Started the fabrication of the LH MGL fairing. I was able to wrap the gear leg and create the foam core. I'm happy with the outcome. I applied Q-cell and filled in the gap between the gear leg and foam core. I'll start wrapping with fiberglass this week. The fiberglass really shrinks when its wetted out!