Fitted remaining ribs and blockage and stiffeners to the wheel well area. On the LH wing I had done this in multiple steps. That is, cut and fit some pieces, glue, wait for it to dry. Repeat on a few more pieces. Wait. Repeat again. Wait... This time I prepped all the pieces and had them all fitting and ready to go and then worked out a sequence of assembly to allow it to all fit together. It was like a 3-dimensional game of Tetris with limited time due to the epoxy curing. Not to mention working with different thicknesses of epoxy. Thickened slightly for gap filling and thin for spreading like varnish. It all worked out but it certainly required a lot of clamps.