1. Attempted to connect the lighting dimmer connectors (a pair of mini Molexes), but for some reason the pins wouldn't mate without several of them being pushed out the back side of one of the connectors. I tried flaring the female sockets slightly, straightening the male pins, and several other techniques, none of which worked. After getting a little frustrated, I realized that I could simply cut off the entire six-conductor wire (Photo 1) and both Molex connectors, and direct-wire the dimmer wires to the controller. Which is what I did! (Photo 2). 2. Secured the annunciator cannon plug and several other wire harnesses nearby. 3. Fabricated the BNC connectors for the VOR/ILS antenna coax and the Com 2 coax, and connected them. 4. Cut off and re-accomplished a Seal-All wing root connector in order to facilitate a slight wire re-route inside the fuselage. 4. Re-routed and secured several large wire bundles near the avionics shelf.