1. Prepped the elevator trim servo wires and connectors for soldering. 2. Final-drilled all attach holes on the HS caps to #30. Countersunk the caps and dimpled the HS skins. 3. Match-drilled and clecoed the right HS cap in place. 4. Sanded and cleaned the inside flange of the HS skins in preparation for gluing. 5. Mixed up some T-88 glue and applied it to the inside flanges of both HS skins. 6. Riveted both HS caps in place. Cleaned up some excess glue that had squeezed out. 7. Removed the L elevator. Installed a 1/4" nutplate in the web of the elevator counterbalance so that I can later add balancing flat washers if needed after the elevators are painted. 8. Removed the elevator trim tab so I could do some minor filler work on it. 9. Shaved and filled all rivets on the elevators that needed it. 10. Filled all the blind rivet heads on the elevators and HS skins.