1. Spent most of the day sanding and filling the seams on the rudder and elevators. I used a bit of spot filler that ended up being a lot quicker drying and was slightly easier to sand than the filler I've been using. I also used an orbital palm sander to knock down the first bit of each line of flox/micro, which sped things up quite a bit. 2. Sanded yesterday's filler on the empennage fairings, and added some more filler. 3. Clecoed the lower fairings into place and drilled new aft side holes for them. This will allow me to tap the attach holes instead of installing nutplates. Opened up all the fairing holes to #27 for screws. Filled the unused hole in each fairing. 3. Cleaned and prepped the six locations for the ClickBond nutplates. Installed all six nutplates--two in the VS, two in the upper skins of the HS, and two in the lower skins of the HS.