1. Sanded and shaped the flox/micro filler on the forward sides of the elevator end caps, rounding the edges to match the profile of the aluminum. This actually came out really nice, and it looks like very little filler should be required. 2. Sanded yesterday's filler on the end cap seams, and applied a light coat of filler primer to everything to check the progress. 3. Did one more round of minor filler on the seams. 4. Sanded the filler on the lower empennage fairings. Added a bit more filler here and there. 5. Used very fine sandpaper to sand the upper empennage fairing. Countersunk the attach holes for #6 finish washers. Did one more light coat of sanding primer. After inspecting it, I think I'm going to call the upper fairing complete!