1. Began working on fixing the seams at the top of the gear leg fairings, which have opened up slightly since they were installed. I will probably also tighten up the fore & aft gaps a bit while I'm at it. 2. The gear leg fairings had slight misalignments when they were installed on the airplane, so I decided to add some small alignment joggles, like I did on the wheel pants. I cut small strips of 0.032" aluminum and flush-riveted them to the edge of the fairing. They work perfectly. 3. Upsized the outboard axle-support holes in each faring to #8, and did the same on the axle supports themselves. 4. Drilled the R inboard wheel pant bracket for #8 nutplates. 5. Re-profiled the L wheelpant to get rid of a slight ridge on the inboard top side. 6. Filled several divots on the trailing edge of the wheelpants. 7. Primed all the parts for a final look.