Match-drilled screw holes for wire cover plate, then drilled holes in baggage wall for nutplates. Trimmed a notch in the plate for the DVR wires, then test-fitted various rubber grommets until I found one that would work. Sanded and filed all edges, then pre-bent the side edges of the cover plate. Cut a small notch in the flange of the baggage wall to allow the rubber grommet to sit flush. [Superseded.] Photo 1: The connector and harness will hardly be noticable behind the DVR unit. Photo 2: This is the view of the harness as it exits the back of the baggage compartment wall.