Several hours to figure out some kind of brace/support for my throttle. After throttle install, it was VERY wiggly when used. I figured out using a couple of cable clamps on the throttle shaft and bracket above it for fuse busses. Clamps connected with tube with smashed ends similar to what I used to brace top of instrument panel. It is 98+% better. Still slight movement but very tolerable and MUCH more secure than previous. Also used cable clamps to secure fuel lines coming from fuel tanks and secured just below the fuel shut-off valves I installed. Both jobs took a lot of thought on my part before several tries to check if proper application before final tightening.