Almost done with the SB00007 Service Bulletin (changing Gear Leg Mounts). Lucio did again most of the work with my assistance. We inserted all the bolts starting from the AN5 in the onboard corner....and then slowly moving into the different sides and bolt sizes. We needed some lubricant but finally we have been able to insert all the bolts. A little help from the rivet gun at very very low pressure for one AN4 at the bottom...very unfortunate location, but at the end even that one went in. I torqued all the AN3, but for the AN4 i need to wait for a bigger torque wrench as mine goes up only to 46lbs/in. As the SB00007 indicates to use selflocking metal bolts (MS21042-3/4/5) i torqued the AN3 to 28+14 (friction)=42 lbs/in. I need to wait for a bigger torque wrench for the others.