Mounted front rudder pedals and started on brakes. Some removal of paint required, which Mark G told me would be needed. Little tweaks with a file, a couple of small holes to drill and the pieces are going together nicely. The Clevis on master cylinders is not deep enough to line the holes up with the attachment hole on the welded brake pedal. I need to verify if it's ok to file the washer-reinforced part on the pedal down until there is enough clearance. Alternatively, the slot in clevis could be cut deeper. This would reduce the amount of adjustment available though. Hole is about 1/8"" off so after filing I would be leaving only about 1/8"" of material adjacent the hole. Perhaps I could do a little of each. Had a line on a compressor. Made an appointment. went to pick it up, and the guy had sold it.