Was monkeying around trying to figure out assembly sequence for the cockpit area prior to covering, so I got the cockpit floors out to see where in the sequence they would need to be installed. Turns out it's pretty early in the scheme of things. The finish on the floors is pretty nice, so I'd hate to scuff it up too badly and planned to cover them in masking paper prior to install. Got me to thinking about heel scuff plates for the rudder pedal areas. It will be easier to install now than anytime later, so I did. Forward ones are stainless steel and bonded in place. The rears are screwed down as there is one floor install screw that needs access underneath the rear plates.