Sing-along: And now the end is near (-- or is it? Anyway,) I did it my way. Lower cowl: My maze of tape showing the outlines of the areas for epoxying of the pieces of heat insulation used for the bottom cowling. These individual pieces were necessary, IMHO, to minimize the wrinkles and the epoxy primer is to keep the ends of the heat shield down. Upper cowl: To seal the filler I also decided to epoxy the complete area around the ramps. A little blue pigment made the mess look a little better despite that it will not normally be seen. Now to let it dry and clean up the work area. Still remaining (at a future date that's TBD) - epoxy resin around the aft edges of the upper cowl to get a better fit.