Today I laid out the controls for the engine; throttle, prop, mixture, cowl exit door, and alternate air then took off all the hardware, seals, etc, in preparation for installation. The cabin heat controls are unwrapped and will be marked for cutting soon. Interesting dilemma: the CT A-700 control (cowl air door) has a label stating not to extend the pull of the cable beyond 3-3/8" or ball bearings will fall out rendering the cable useless. However, OP62-26 step 2 states to cut the cable and also states to pull the knob out 6" for the cut. I'm confused, so a call to tech support may be in order. I also installed the F-14107-1 plate (engine controls) in place on the instrument panel. I then loosely installed the prop control cable in place.