I went to work on the second set of Adel clamps for Heat Tee and decided to fabricate another aluminum tube spacer as on the first one. With that done came the compressing of the clamps and adjusting the Heat Tee for the final location fitment. This one was just as difficult as the first, no learning curve. Anyway, it's done. Second clamp and fitting of the Heat Tee is now done. I did another test fit of the hoses and they don't fit. I can readjust two the three, but I'll had to order new SCAT tubing for the final one. Lesson learned! Don't cut the SCAT tube until each one is fitted. The directions for the length of each hose aren't even close because the Heat Tee doesn't go on as depicted. Oh well. build on.