Although I plan to use the aft rudder position, I realize it is probably better to go ahead and do the work now to accommodate the forward position in case I get taller some day. I had previously run the crossover brake lines below the center support and realize now that they'd be in the way of sliding the pedals back. Thankfully the hole I drilled for the adel clamp is exactly where it needs to be for the rear rudder position. So unbolted everything and slid the side support brackets back to the rear position. The match drilled the center support block in the rear position. Ran the crossover cables above the center bracket and drilled a hole through the too flange. Decided to install a nut plate to maybe make it easier to remove in the future. Maybe. It's going to be very tight up in there but at least now you'll only need to get one wrench on it and not two. That's it. Can disassemble it all now and prime a few parts.