Got the upholstery and had to see what it looks like! It looks very cool. I installed the seat and back on the front seats so I could sit in it, and it is quite comfortable, too. I am glad I'm not a super tall person (I'm *almost* 5'10") because these are some thick and squishy seats! If I were taller, I'd need to cut the foam down some. Lucky for me I'm not. For the front seats, I cleaned the surfaces with alcohol and then laid the map pocket in place. When I liked where it was sitting, I pulled the tape off of the back of the Velcro-Like Substance (VLS) that will hold the upholstery in place but also let me peel it off. The map pocket was touch because of the elastic, but I got it working. The seat back needed some stretching to get over the seat back, but not much. Once it was on, I reached my hand up under the seat back to pull the paper off the VLS (two strips) and then pushed it hard against the aluminum. For the seat bottoms, it was a similar process. I pulled the white paper off the VLS that goes closest to the seat back, got it lined up, and pushed it down. I then did the same with the three pieces of VLS in the front of the seat, and then I got to sit on the seat and enjoy the luxury of it all. Pretty easy, and also very rewarding!!