Started installing the pitot tube into the left wing. I am installing the Garmin heated version of the pitot tube. My goal was to install the pitot tube so I can remove it without taking the wing apart should it require maintenance. There will be an access port at the lower wing that will allow me to disconnect the tubing from the pitot tube itself as well as disconnect/remove the heater controller. With the bend in the hard line tubes I am able to remove the pitot tube from the mast without issue and still meet the Garmin requirement to keep the tubing as long as possible. However I felt that with that configuration, I needed to support the tubes a bit so they just didn't vibrate in free space. I added a support to hold the tubing. I put a clear piece of tygon tubing around the aluminum tubing and then made a clip that holds the aluminum tubing against the support. That clip screws into a nut plate to make it easier to remove/install through that wing access point. Got it all installed but not permanently since there is plenty left to do on the wing itself. I also added a spacer to my magnetometer mounting plate to support the electrical connector. It uses a standard DB9 connector but in my install, this is the end of my CANBUS so it also has a termination in there making the overall connector pretty long. The spacer will support the connector and the termination.