Finishing up some stuff today that I had started on but didn't totally complete. I had installed the rack for the transponder, built the ground plane for the antenna and then never installed the antenna and the antenna cable. So that was first on today's list. I had built some close outs for the horizontal stab braces using an older Kitfox version as a model. (I liked it better than the current one) Installed the bracket on the stab and made the plates to close them out but never opened up the plate to allow the brace itself to clear. That hole has to clear the brace during the whole trim range of motion. So that was second on the list and got both sides completed and ran the trim through the full range to verify the clearance. The third thing on the list required beer. I successfully completed that as well.