Been working on the Companion since I got home from work Monday. �Mainly working on the bottom cowl and the carb airbox with a few other goodies thrown in. It was with much trepidation that I started cutting into the bottom cowl that took so long to get perfect, but it needed a big hole so it got a big hole. �viously it is a start small and enlarge as needed. �arted by tracing the carb for positioning, then took the cowl off set the airbox on it and then started tracing the outline once again starting a bit small allowing for cutting more to fit. With the airbox on, I can now install the Carb Heat control cable, so I did that as well.