Well, I showed the result of soldering with the 22 gauge wire to my friend Al. He pointed out to me that I should have added some shrink tubing over the soldered area - to relieve some strain from the wires. So, I unsoldered and soldered back - this time with shrink tubing. Of course - he was correct - this is much nicer. You might also notice in this picture that the two middle switches are installed upside down. This is on purpose because - they are the Mag switches. When a Mag is turned off - the circuit "closes" - thereby grounding the Mag. Most switches, for lights, etc., will be "Open" when in the down position - turning off the light.