Fabbed the hinge pin anchors that secure the hinge pins from vibrating aft/out of the wingtip. Drilled the cutting board block (1/2”) for the pins and the #10 screw that will hold it secure it to the wingtip rib. Riveted the nutplate in place on the wingtip rib.
Received some #6-40 stainless screws from Mike Bullock that he used on his pitot tube as he had a lot extra per his build site. Tapped the pitot tube for 6-40 screws without damaging the pitot lines or the electrical wires, at least I think. Thanks a bunch for the screws Mike.