Used some scrap throttle bracket to check the fit of my alt static switch and the protective cover. Seems like it will work well. Now to find some space on the panel to mount it. Received the spacers for the stick grips from Infinity that increase the OD of the stick to fit the ID (1”) of the stick grip. This looks like it will work well after I determine the proper length of the stick, but I need to install the panel to find that, so stick grip progress is on hold til then. Decided to install the engine sensor harness and EGT/CHT (brown wires) harness to the SV-EMS-220. The engine sensor harness connector thumb screws did not want to cooperate, but I was finally able to secure it after getting it exactly square to the opposing connector on the SV-EMS-220. Routed the associated wires from each harness to the appropriate firewall pass through and temporarily taped each wire to the corresponding engine sensor wire (EGT/CHT). Then began process of labeling and routing all the engine sensor wires in the correct portion of the aircraft. LOTS of wires to try and figure out the best and correct placement of each. Trying to not get overwhelmed by the myriad of wires and remember “one wire at a time”. :)