Installed the A/C Drain Tubes. But prior to that I realized that I needed to connect the Autopilot Yaw Servo Cables to the Rudder Cables. This was more of a chore that I expected, since I had put the Center Aft Bulkhead Channel in yesterday and it kind of restricted my access to the Tail Cone. First I clamped the rudder in the neutral position, then pulled the rudder cables taught. I do wish I had three hands sometimes. Holding the servo cable clamps in position while tightening the nuts was the issue. The lightbulb went off and I used Cleco Clamps on the Cable Clamps to hold them in position while I adjusted them and tightened the nuts. The A/C Drain was simple and the Blower Box Drain lined up nicely with the fuselage drain. I may have to make a slight adjustment when I get the Battery Vent Drain in position. So, great... I get to crawl back up inside there to install that drain.