Actually got back to work on the doors. Started to trim the edges. The angle grinder with a thin cutoff wheel got the majority. Then I switched to a flapper wheel to get a closer fit. Then finishing with the Perma-Grit sanding block and Dremel tool. Lot's of on-and-off. I have quite a bit more to do, but it was a good start to see how it will fit and how much I need to trim off. I cut some angle aluminum and drilled #40 holes in the doors to cleco the doors in place after I cut off the alignment tabs on the doors. Then I used a drum sanding attachment for the inside radius curves.