Drawing 25 has a detail view of some simple clips that are to be made out of .025 strap bent into a sort of Adel clamp shape and riveted on the back side of the longerons in the tailcone "as needed" between bulkheads to support the static line run fwd.

I had to think about it a while to figure out the simplest way to make these, but basically I started with a piece of .025" shim stock cut into 2" chunks and then just wrapped them around a piece of 1/4 bar stock & a 1/4" drill bit held in a bench vise.

Still not sure if I'll use these or not, but it was a simple project that was kind of fun to think through.