Finished making the four cable guards for the pulleys. Built the two levers for the adjustable rudder pedals. Painted the bottom end of the flap lever where I had to grind a little bit away for it to fit in the fuselage. Then, I installed the pedals so I can start working on the rudder cables.

I think it might be a good idea to build all of the fuel lines before I get into fabric covering. I think it just might be easier while there is no skin on the airplane. So this evening I mounted the header tank. It's just cleco'd in place for now so I can remove it later and install the fittings. At this point, I'm not completely sure of the fuel line routing, or the correct size of fuel line to use for the Rotax 912iS engine. So some more research is needed before I start making the aluminum fuel lines.