Received clarification from the factory on whether it should have 1 or 2 lifting plates - they clarified it is only 1. After shortening the top tie strap, finished installing the rocket tube. Ran the parachute pull cable from the back, down the center channel and to front awaiting the panel installation. The actual rocket motor won't get installed until closer to first flight.

Because there are several things to work on inside the cabin, I decided to temporarily rivet the rear floor and seat back close out skin with a few rivets for strength. The boards I had on top of the ribs just seemed to flex them too much for my liking so adding the floor skins with boards will make it easier to move around the cabin with less concern of damaging something.