Fixed a front swinging window which dropped off the table, denting the lower exterior sheet metal. More was purchased, fit, and riveted on.

Both swinging windows have the acrylic cut.

Otherwise progress has been slow, particularly installing fuel lines in the fuse. Weather has been too cold to wok outside. I have to order new tubing. Will try 3003 tubing in a couple from ACS. Hopefully I can make the compound bends more easily,

Rear windows are cut. The 2.5 mm acrylic will not fit in the slot between outer and inner frames. Some people including Avipro say pry it apart. So far no joy. I set up an angled table on a router table and then used it to chamfer the outer 1/2” of the acrylic pane. Still doesn't fit but much closer. Prying and more shaping may serve.