Put the new saw blade on the table saw and made the first cuts for F3 and F4. Douglas Fir and Sitka Spruce. Unfortunately I did not check the new blade to be sure it was 90?. I had to re-cut the boards. All boards had to be planed to nches. I found that my table saw is about 3?off. Now cuts are at 90?. As a first step in my project I started on the cockpit bulkheads (F3 and F4 in the plans). This was also my first use of the T88 epoxy for joining wood. I put a couple pieces of scrap Sitka Spruce in the vise after it dried. This stuff is great the glue joint held and the wood splinters!