I installed oil temperature sensor, no issues here. Spent the majority of time routing and rerouting the cable bundles and temporarily installed the connectors to the ACM and other components. The reason for this is to keep the wire bundles from hanging too low, not rubbing against anything sharp, etc and to be sure the lengths are correct. So far it's fine. However, I did discover the ADS-B unit was about 3/4" of inch to high because when installed, the connector was just too close to where the canopy would close. I moved the unit down - problem solved. However, it's sitting at about .4 degrees off of vertical. It must be that the transponder is slightly off. Since it's purely aesthetic, I'll get to when I can. I know I'm being anal, but....