Shot 2nd coat of paint on underside of panel visor. Ready to install. Terminated electronic ignition coil RG400 wires with spade connectors. Plugged wires into respective coils and tightened down mounting bolts with Loctite. Loosened all bottom plugs in prep for removal prior to coil firing test.#4 cylinder plug adaptor came loose with plug to I cleaned the threads and applied anti-seize compound along with a new copper gasket. Installed the adaptor with 40 ft. lbs. torque as required. Cut and fit 2" SCAT tube for fresh air vents. Finally, I gently squeezed the #6 RIVNUTS that will secure the avionics cooling fan to the glareshield..These are also secured with CA glue. I used d-sub pins to terminate the fan wires. They are then covered with shrink wrap. If you need to unplug for any reason in the future, just slit the shrink wrap and unplug. Fan is ready to install. Will use this same technique to terminate the panel visor LED strip lights.