Modifications and Additions:
Empennage:
- Ran conduit and installed doubler and nutplates for VS mounted NAV antenna (As a contingency in case Archer antennas don't work well)
- Installed Garmin pitch servo bracket
- Installed RV-14 Yaw Damper bracket with minor modifications for RV-10. Use with RV-10 Bow from Garmin.
- Installed upgraded Static ports from Cleaveland Tool
- Installed nut plates in bottom rudder fairing to make removable
- Purchased and drilled holes for ADAHRS bracket, but likely not going to use
- Aeroled tail light

Wing:
- Aluminum pitot mount
- Garmin Regulated Pitot/AOA
- FlyLED seven star landing light.
- Aeroled nav/strobe lights
- Ductwork leading edge light kit
- GMU22 Magnetometer bracket near tip
- Bob Archer wingtip NAV antenn
- Electric aileron trim
- Roll Auto-pilot servo mount
- Warner Fuel Sending units
- (Planned) Icing proof fuel vent? https://vansairforce.net/community/showthread.php?p=21691
- (Planned) Fuel caps?
- Installed extra bung for possible fuel return line - capped
- Stainless hex head screws for installation of fuel sending units
- Inadvertent use of LP4 rivets on left aileron end ribs instead of CS4. Looks fine. Went ahead and did the same on right aileron to match.
- Fiberglassed over the wingtip trailing edge rib to close up hole and just generally better finish.

Fuselage:
- (Planned) Tosten Grips or Pioneer?
- Andair fuel valve - FS20-7T with 90 degree fittings on left and right and straight AN fitting out bottom
- Stainless Heater Box
- TS Flightlines brake lines at pedals and gear legs
- installed return springs on brake master cylinders to reduce brake drag.
- (Planned) TS Flightlines wing root filters
- (ordered) Airflow systems air conditioner
- (Planned) Aerosport center console w/o throttle
- (Planned) Aerosport overhead console
- A pillar conduit run to overhead? GPS, lighting
- Overhead pod? Lighting, Heat, AC controls?
- (Planned) Leaning toward stock panel - hydrodip?
- access panels for landing gear mount. 45 degree bolt install, TCW bushings
- 3M fire stop around firewall
- Airward tunnel access kit - just on co-pilot side
- Com antenna doubler under rear left passenger seat
- transponder antenna under copilot seat

Finish:
- (Planned) Plane around door handles
- (Planned) Low profile handles
- (Planned) Sikaflex (sikadur?) window attach?
- (Planned) upgraded Matco brakes
- (Planned) heavy duty door struts

FWF:
- (Planned) lava shield
- (Planned) TCW vent control servos
- (Planned) TCW oil cooler servo
- (Planned) Red Cube mount FWF