Reran the pilot and copilot headset wires down the middle to the center console. Looks like I will be ble to fit traditional jacks and Lemo jacks in there.

Ran the remainder of the power wires this morning until I ran out out of ground wire and ran out of labels again. Still have a few miscellaneous wires to run but 95% of the wires are run. Certainly enough to take it off the board and trial fit everything in the panel.

Everything is pretty good except in double flipping the orientation of the harness on the board I ended up getting it upside down. It's fine, but I intended the power wires be in the bottom. It actually probably looks better with all the white wires in bottom - we'll see.

With the harness in place below the panel, I was able to finalize locations of a few items and start finishing out the subpanel work.