My fuselage is finally fully covered. The last top section is done and for all who read this and are thinking about using Oratex, that curved transition to the vertical stab has been the hardest part of all to cover for me. Getting the material to lay over that curve was a bear. I needed to use the heat gun to do it with the wife pulling on the material to get it. I had to cut small strips to relieve much of the stress and then we did each small section one at a time. I still have to do the finish tapes along the top center there and know that there is a trick to that as well but don't think it will be as much of an issue as this was. My panel layout, cutting and fitting is complete. I decided to send the panel to Stein Aircraft to do the engraving and labels. My experience getting this set up was the same as my experience buying the avionics: great. They estimate 3 to 5 weeks to get the panel back to me.