Last week I noted the rear seats didnt fit correctly. It turns out there are two different ways they could have been installed (also not specified in the plans) and I choose poorly. I drilled the hinge out and reinstalled. The rear seats now fit as they should. I also finished up the rear cargo floor by installing the inspection covers and also fabricating a cover plate for what would have been a rocket exhaust port if I had installed the ballistic chute.

I also temp installed the center console so that I could figure out how i wanted to secure wires inside of the center console but to also make and install the audio and mic jacks for both front seats and I also installed a USB charge port for the back seat. Its a tight fit between the flap motor and the USB charge port but I am comfortable with how I secured it.

After that I started to finish up the covers for the front of the wing spar. I found that some of the factory locations for riv nuts dont line up so I had to rework a few things.

Lastly I ordered CEET tubing so I can run hot air lines for the back seats.