I have been using a folding 6' utility table. It's too small, not very sturdy, and too low, so it hurts my back. Dropped a plane door off it a while back, requiring replacement of some sheet metal. Enough frustration!
I built this new table which is wide enough to support both wing spars simultaneously if required and is about 7'4” long. Made mostly from recycled 4X4 bolted with 1/2 lap joints. It can support toolboxes or large portable tools on the bottom shelf. The middle shelf is very light duty (3/8” ply) for holding hand tools, bolts, rivets or whatever it instead of having them around and under the workpiece at hand. I am going to put heavy duty wheels which rotate up off the floor whenever the table is in the desired location. This mobility is essential since my shop is small. The bench will have to go out the garage door to move it past the fuselage.