Jan 26, 2019     Corrected Mistake - (1 hour) Category: RearLowrFuse

Finished installing new lower rudder horns

  Jan 26, 2019     Corrected Mistake - (2 hours) Category: RearLowrFuse

Installed new lower rudder horns

  Jan 19, 2019     Priming - (1 hour)       Category: RearLowrFuse

Spray Nason 491-40 Primer

  Jan 14, 2019     Corrected Mistake - (2 hours) Category: RearLowrFuse

Replaced Z on left side of access panel, which was damaged while drilling the holes for the panel screws. I had to cut another and move it about 2-3mm outboard so that there was room for the nutplates without hitting the upright/bend in the Z. This left the rivet holes a bit close to the edge nearest the cutout. To correct this, I installed several new rivets along the real centerline of the new Z, spaced evenly between the existing holes, avoiding interference with the nutplates. Installed and riveted the nutplates.

  Jan 13, 2019     Final Assembly - (6 hours)       Category: RearLowrFuse

Spray Zinc Phosphate. Final assembly and riveting.

  Jan 12, 2019     Disassembly - (7 hours) Category: RearLowrFuse

Disassemble, debur, AlumiPrep and Alodine

  Jan 11, 2019     Final Hole Drilling - (2 hours) Category: RearLowrFuse

  Jan 10, 2019     Z's - (1 hour) Category: RearLowrFuse

Z's, Hinge, and Access door fitting, filing, and drilling

  Jan 09, 2019     Lower Rudder Hinge - (2 hours) Category: RearLowrFuse

Lower rudder hinge and tie down ring. Not happy with hole alignment between upper and lower horn. Ordered replacements.

  Jan 07, 2019     Longerons - (4 hours)       Category: RearLowrFuse

Longeron fit and pilot drilling, including shim, doubler, etc. Trimming Stiffeners after installing longerons.

  Jan 06, 2019     Z's - (3 hours) Category: RearLowrFuse

Fitting, trimming and drilling Z's

  Jan 05, 2019     Assembly - (4 hours)       Category: RearLowrFuse

Cut fairlead material, drilled horizontal tail frame, cleanup in preparation for bottom skin to take up whole table. Laying out and drilling L's, Z's, etc.

  Jan 04, 2019     Started - (1 hour) Category: RearLowrFuse

Started rear horizontal tail frame. May have messed up 6B-1-5, may have to replace.