Apr 21, 2024     Mount Category: Engine

Finished tack welding engine mount. Removed from jig and test fit to firewall and engine. Fits good. Replaced in the jig

  Apr 20, 2024     Mount       Category: Engine

Tack welded tubes at the firewall side

  Apr 17, 2024     Mount Category: Firewall

Drilled new holes in mount plate due to the threaded rod being in the way of the tubing. Reassembled jig with 1 degree right offset. Started to place tubes into position

  Apr 15, 2024     Mount Category: Firewall

Removed engine from firewall. Removed u-brackets from mount and secured to engine mount jig.

  Apr 14, 2024     Mount Category: Firewall

Verified dimensions of firewall holes. Drilled mount. Marked location of engine mount plate on jig and drilled thru plate onto firewall plate. The engine plate is offset to the left due to the 1 degree right thrust

  Apr 12, 2024     Jig - (0.5 hour) Category: Engine

Cut 3/4" plywood for base of engine mount jig. Tubing kit from VR3 arrived

  Apr 10, 2024     Mount Category: Engine

VR3 shipped engine mount kit

  Mar 28, 2024     Lugs Category: Engine

Pressed out prop lugs and reinstalled in outside pattern to match prop hub

  Mar 25, 2024     Fittings - (1 hour) Category: Firewall

Drilled out bulkhead eyeball pass thru fitting to fit mixture and throttle cables. Installed fittings. Emailed VR3 engine mount drawing with new dimensions.

  Mar 18, 2024     Cable - (1 hour)       Category: Instrument Panel

Installed the mixture, throttle, and carb heat cables. Labeled carb heat. Still need to install cables in firewall pass thru bulkhead